[Contents]
G Trigger ver.2 x 1
This is a realistic Glock stock-type trigger.
The genuine Glock trigger has no exposed pin on the right side.
This trigger reproduces that part, as well as the R-shapes and detailed contours in various places, as much as possible.
For this ver.2, the surface treatment has been changed to reproduce a strong texture.
If you have purchased a G Trigger before and wish to match the texture of ver.1, you can achieve a relatively similar surface by sanding it with sandpaper or similar.
When installing, please reuse the following from a Marui or similar plastic trigger:
・Trigger safety
・Pins x2
Please shave off about 1mm from the pin length before inserting them.
Since there are slight differences in pin length depending on the manufacturer (Marui, WE, VFC, etc.) and model, please adjust it to fit the actual item.
As a guideline, if the pin length becomes 8.4mm, it should be almost flush with the trigger.
Also, please note that depending on the manufacturer of the parts you are reusing, some adjustment may be required with the trigger safety.
Recommended are:
Guarder Trigger Safety Pin
GunsModify Trigger Safety Pin
Due to its structure, it is almost impossible to remove the pin once inserted while maintaining the external appearance of the trigger, so please pay attention to the orientation of the parts when installing.
Also, since the main body is made of resin, just like the real thing, it is likely compatible with various manufacturers' models depending on the processing.
Currently, we have confirmed operation with:
Tokyo Marui Glock Series (all)
UMAREX Glock Series (all)
WE・AW Glock Series
Some manufacturers may require additional processing on the:
Trigger
Trigger bar
*This is a custom part for advanced users.
Please only purchase if you can install and adjust it yourself.
Please note that we do not provide any support regarding installation or operation.
//Produced by//
The “ S ” Airsoft
